UA-69298255-1 Blog Little P.Eng. for Engineers Training

August 26, 2019

Little P.Eng. for Engineers Training Proudly offers the most affordable courses in California; ASME B31.3 is one of them. This specialist course provides complete comprehensive coverage of ASME B31.3 - Process Piping Code requirements for the design, construction and i...

August 21, 2019

ASME B31.3 is the governing standard for pressure piping in USA.  Also, ASME B31.3 is one of the more commonly used pressure piping codes in the world.  The purpose of this 15 hours piping design training course is to provide guidance and instruction in the areas of pi...

March 27, 2018

The Designer may have more than one thermal expansion or other displacement cycle conditions to consider. Cycles at lower stress ranges are substantially less damaging than cycles at higher stress ranges. ASME B31.3 uses the cycle with the highest stress range (full di...

March 16, 2018

Allowable Stress For Thermal Expansion

The allowable stress for thermal expansion and other deformation-induced stresses is substantially higher than for sustained loads. This is due to the difference between load-controlled conditions, such as weight and pressure, and...

March 16, 2018

The participant of this seminar will have an overview of the codes and standards governing the design of pressure retaining components and the piping design process. By the end of the seminar, the participant will understand pipe sizing for various flow conditions and...

March 11, 2018

Sustained loads and Occasional loads are among the most important concerns as per ASME B31.3 Code. Thus, Little P.Eng. For Engineers Training explains in detail how to design piping systems against Primary Longitudinal Stress, Sustained Longitudinal Stress and their li...

October 2, 2017

Responding to evident need and at the request of The American Society of Mechanical Engineers, the American Standards Association initiated Project B31 in March 1926, with ASME as sole administrative sponsor. The breadth of the field involved required that membership o...

September 25, 2017

Caulked and soldered joints are only permitted in Category D Fluid Service. Caulked joints are further limited to a maximum temperature of 93°C (200°F), and provisions are required to prevent disengagement of the joints and resist the effects of longitudinal forces due...

September 21, 2017

Tubing joints are covered by para. 315, and include flared, flareless, and compression-type tube fittings. ASME B31.3 provides some listed tubing joints; however, many tubing joints used in process piping are proprietary fittings that are qualified as unlisted componen...

Please reload

Categories

LITTLE P.ENG. FOR ENGINEERS TRAINING

3705 Fonda Way #18 Southeast Calgary, T2A 6G9

Canada

Bay area, California

Stay Connected

  • Yelp Social Icon
  • Facebook Social Icon
  • Twitter Social Icon
  • LinkedIn Social Icon
  • yp-logo-original
  • Yelp Social Icon
  • Google Places Social Icon
  • Pinterest Social Icon