top of page
LITTLE P.ENG. FOR ENGINEERING CONSULTANCY SERVICES
If you are looking for CANADA / US BASED Engineering Consultant Services ; Little P.Eng. for Engineering Services is ready to help you across Canada, USA and Arabian Gulf Area.
+1 (587) 802-4050
Search


2.1.1 Minimum Wall Thickness Requirements
Since hoop pressure stresses are approximately twice as large as longitudinal pressure stresses, pipe wall thicknesses are initially sized for hoop stresses. Because of this, pressure design of components is usually done far before, and therefore in isolation, from the pipe stress analysis phase of piping design. Because of this, pipe stress software such as CAESAR II does not normally handle this part of the design effort. A discussion of pressure design of components is inc

Meena Rezkallah, P.Eng.
May 17, 20202 min read


2.1 Designing For Sustained Loads — Pressure
All piping systems must be designed to withstand sustained loadings. Sustained loads are classified as those caused by mechanical forces which are present throughout the normal operation of the piping system. Therefore these loads: Are force driven, as opposed to displacement driven, and Are present for relatively extended periods of time, as opposed to those which change dynamically. Typical sustained loads consist of: Pressure — loads due to operating (or design) press

Meena Rezkallah, P.Eng.
May 17, 20201 min read
Pipe Stress Analysis Notes
Meena Rezkllah presents a full guide and tutorials to everything related to pipe stress analysis and computer aided programs like CAESAR II

Meena Rezkallah, P.Eng.
May 17, 20201 min read


2.0 Piping Design For Loading Types
As described in Introduction to Pipe Stress Analysis, the pipe stress analyst is concerned with two types of loads — primary and secondary. Not only are the causes and the failure modes of these two loading types quite different, but not surprisingly, the solutions to these two types of loading are usually different as well. In fact, the solution to a problem caused by one of the loading types often causes a problem with the other loading type. Therefore, a compromise must of

Meena Rezkallah, P.Eng.
May 17, 20202 min read


1.5.12 Evaluation of Multiple Expansion Range Cases
It is often the cases that the temperature of the piping system is not constant throughout the operating cycle, or there is potentially more than one operating cycle (i.e., pump A on, pump B on, both pumps on, both pumps off). In these cases it is common to find that the temperature rises on some occasion to a maximum value, say Te; then, as events occur during the normal course of operation the temperature varies between Te and other lower temperature states, say T1, T2,...,

Meena Rezkallah, P.Eng.
May 17, 20204 min read
bottom of page
