top of page
LITTLE P.ENG. FOR ENGINEERING CONSULTANCY SERVICES
If you are looking for CANADA / US BASED Engineering Consultant Services ; Little P.Eng. for Engineering Services is ready to help you across Canada, USA and Arabian Gulf Area.
+1 (587) 802-4050
Search


2.3.4 Use of Expansion Loops in Piping Design & Stress Analysis
In the event that model refinement is not sufficient to solve the problem (i.e., there is a real problem, and not just one on paper), something must be done. Re-examining the equation for the guided cantilever model: It is evident that the stress analyst cannot easily change the terms 6, E, R, or delta. This leaves only 1, the length of the leg absorbing the thermal growth. This can be done through the addition of an expansion loop. In this case, the thermal growth is partial

Meena Rezkallah, P.Eng.
Jun 3, 20201 min read


2.3.3 Refining the Model Through the Use of Restraint Stiffnesses
What if the calculated expansion stress range is too high? How can we reduce it? Consider the initial example, with the pipe fully anchored at its ends. What would happen in real life? The restraints would probably bend some under the enormous load, allowing some piping expansion, which would then reduce the internal load (since expansion loads are self limiting). What happens if the bending of a support — i.e., its flexibility — is explicitly considered in the analysis? (No

Meena Rezkallah, P.Eng.
Jun 3, 20202 min read


2.3.2 Guided Cantilever Method
Guided Cantilever Method, Pipe Stress Analysis, Piping Flexibility, Thermal Expansion, CAESAR II, and ASME B31.3.

Meena Rezkallah, P.Eng.
Jun 2, 20202 min read


2.3.1 Magnitude of Thermal Load Due to pipe Expansion
A piping system, when heating up, normally tries to expand against its restraints, resulting in internal forces, moments and stresses: The axial force generated in the above configuration can be estimated to be the axial force required to compress the pipe back to its original length after it has been allowed to grow freely. Its free growth is: The axial force required to compress that growth is: Considering a rather benign operation — a 12-inch diameter, standard wall pipe

Meena Rezkallah, P.Eng.
Jun 1, 20202 min read


2.2.3 Consideration of Nozzle Loads
The previous discussion has primarily concerned the effect of supports on system stresses. The engineer is also interested in determining loads on supports and nozzles, in order to select the appropriate support hardware, to check the overloading of equipment, or to calculate vessel stresses. A review of the restraint loads shows that the hanger loads are on the order of 2000 to 3000 pounds. These loads would be used as an upper limit for the selection of the support hardwar

Meena Rezkallah, P.Eng.
Jun 1, 20203 min read
bottom of page
