top of page
LITTLE P.ENG. FOR ENGINEERING CONSULTANCY SERVICES
If you are looking for CANADA / US BASED Engineering Consultant Services ; Little P.Eng. for Engineering Services is ready to help you across Canada, USA and Arabian Gulf Area.
+1 (587) 802-4050
Search


2.1.5 Restraint of Unbalanced Expansion Joint Pressure Loads
Pressure usually only creates stress in the pipe, rather than loadings on supports/restraints, because pressure loads are neutralized at the cross-section by the tension in the pipe wall. One exception to this is when the pipe is not continuous from anchor to anchor, such that tension is not present in the pipe wall at all locations of the system. (Note that a second exception occurs when the Bourdon effects of pressure are considered. The Bourdon effect is due to the axial e

Meena Rezkallah, P.Eng.
May 20, 20202 min read


2.1.4 Pressure Design of Branch Connections
A pipe having a branch connection is weakened by the opening that is cut in it, so it may be necessary to provide reinforcement to replace the metal removed from the wall thickness at the opening. A typical fabricated tee is shown in Figure 2-2. For fabricated tees, with the angle between branch and header of at least 45°, the area required to replace the area of the opening is calculated as: PRESSURE DESIGN OF BRANCH CONNECTIONS | ASME B31.3 Branch Reinforcement, Fabricated

Meena Rezkallah, P.Eng.
May 20, 20201 min read
3.0 Modeling And Analysis Of The Piping System
The first two sections of these pipe stress analysis notes have served to give the user an overview of the requirements of pipe stress...

Meena Rezkallah, P.Eng.
May 19, 20202 min read


2.1.3 Pressure Design of Flanges and Blanks
Pressure design of flanges is a complex task, requiring consideration of the configuration and materials of the flange, bolts, and gasket. Potential causes of failure are bending stresses in the flange, localized stress concentrations in the hub, yielding of the bolts, or unloading of the gasket, causing leakage. Design of flanges is covered in detail in Section VIII of the ASME Boiler an Pressure Vessel Code; however, due to the complexity, it is rarely done by the pipe stre

Meena Rezkallah, P.Eng.
May 19, 20201 min read


2.1.2 Pressure Design of Elbows and Miters
When using elbows, the minimum wall thickness after bending shall not fall below that calculated for straight pipe. For mitered elbows, the maximum allowable pressure is calculated differently depending on whether the angle of the miter cut is less than or greater than 22.5°. 2.1.2 Pressure Design of Elbows and Miters Read More: Piping Design For Loading Types To get our piping stress analysis services, please contact our piping engineering firm for a free quote.

Meena Rezkallah, P.Eng.
May 18, 20201 min read
bottom of page
