top of page
LITTLE P.ENG. FOR ENGINEERING CONSULTANCY SERVICES
If you are looking for CANADA / US BASED Engineering Consultant Services ; Little P.Eng. for Engineering Services is ready to help you across Canada, USA and Arabian Gulf Area.
+1 (587) 802-4050
Search


2.3.2 Guided Cantilever Method
Guided Cantilever Method, Pipe Stress Analysis, Piping Flexibility, Thermal Expansion, CAESAR II, and ASME B31.3.

Meena Rezkallah, P.Eng.
Jun 2, 20202 min read


2.3.1 Magnitude of Thermal Load Due to pipe Expansion
A piping system, when heating up, normally tries to expand against its restraints, resulting in internal forces, moments and stresses: The axial force generated in the above configuration can be estimated to be the axial force required to compress the pipe back to its original length after it has been allowed to grow freely. Its free growth is: The axial force required to compress that growth is: Considering a rather benign operation — a 12-inch diameter, standard wall pipe

Meena Rezkallah, P.Eng.
Jun 1, 20202 min read


2.2.3 Consideration of Nozzle Loads
The previous discussion has primarily concerned the effect of supports on system stresses. The engineer is also interested in determining loads on supports and nozzles, in order to select the appropriate support hardware, to check the overloading of equipment, or to calculate vessel stresses. A review of the restraint loads shows that the hanger loads are on the order of 2000 to 3000 pounds. These loads would be used as an upper limit for the selection of the support hardwar

Meena Rezkallah, P.Eng.
Jun 1, 20203 min read


2.2.2 Use of Standard Weight Spans
Implementation of the preceding analysis provides a simple way to design for weight loading. The engineer may first support all concentrated loads in the system as closely as possible, reducing the stresses due to those loads to near zero. Next, converting the formula If the piping system is then supported, such that no straight span exceeds Lall, the engineer can be sure that allowable weight stresses are not exceeded in the system, and no analysis per se need be done. Pip

Meena Rezkallah, P.Eng.
May 31, 20205 min read


2.3.6 Stress Reduction through Use of Expansion Joints
In extreme cases, expansion joints may be added to a system in order to increase flexibility when there is insufficient room for a loop....

Meena Rezkallah, P.Eng.
May 31, 20202 min read
bottom of page
