top of page
LITTLE P.ENG. FOR ENGINEERING CONSULTANCY SERVICES
If you are looking for CANADA / US BASED Engineering Consultant Services ; Little P.Eng. for Engineering Services is ready to help you across Canada, USA and Arabian Gulf Area.
+1 (587) 802-4050
Search


2.2.1 Calculation of Weight Stresses
Stresses due to weight loads acting on a supported pipe can be estimated through the use of beam theory. The simplest method of estimating pipe stresses due to weight is to first consider the pipe as being a continuous run, with supports located at constant intervals (this is a somewhat accurate model of piping traveling horizontally, mounted on racks, and with a minimum of in-line components): Elementary beam theory can be used to determine stresses in a member due to loadin

Meena Rezkallah, P.Eng.
May 21, 20202 min read


2.1.5 Restraint of Unbalanced Expansion Joint Pressure Loads
Pressure usually only creates stress in the pipe, rather than loadings on supports/restraints, because pressure loads are neutralized at the cross-section by the tension in the pipe wall. One exception to this is when the pipe is not continuous from anchor to anchor, such that tension is not present in the pipe wall at all locations of the system. (Note that a second exception occurs when the Bourdon effects of pressure are considered. The Bourdon effect is due to the axial e

Meena Rezkallah, P.Eng.
May 20, 20202 min read


2.1.4 Pressure Design of Branch Connections
A pipe having a branch connection is weakened by the opening that is cut in it, so it may be necessary to provide reinforcement to replace the metal removed from the wall thickness at the opening. A typical fabricated tee is shown in Figure 2-2. For fabricated tees, with the angle between branch and header of at least 45°, the area required to replace the area of the opening is calculated as: PRESSURE DESIGN OF BRANCH CONNECTIONS | ASME B31.3 Branch Reinforcement, Fabricated

Meena Rezkallah, P.Eng.
May 20, 20201 min read
3.0 Modeling And Analysis Of The Piping System
The first two sections of these pipe stress analysis notes have served to give the user an overview of the requirements of pipe stress...

Meena Rezkallah, P.Eng.
May 19, 20202 min read


2.1.3 Pressure Design of Flanges and Blanks
Pressure design of flanges is a complex task, requiring consideration of the configuration and materials of the flange, bolts, and gasket. Potential causes of failure are bending stresses in the flange, localized stress concentrations in the hub, yielding of the bolts, or unloading of the gasket, causing leakage. Design of flanges is covered in detail in Section VIII of the ASME Boiler an Pressure Vessel Code; however, due to the complexity, it is rarely done by the pipe stre

Meena Rezkallah, P.Eng.
May 19, 20201 min read
bottom of page
