top of page
LITTLE P.ENG. FOR ENGINEERING CONSULTANCY SERVICES
If you are looking for CANADA / US BASED Engineering Consultant Services ; Little P.Eng. for Engineering Services is ready to help you across Canada, USA and Arabian Gulf Area.
+1 (587) 802-4050
Search


2.4 Hanger Design
As seen in Section 2.2 located at (Piping Design for Loading Types), as more restraint is provided to a piping system, weight stresses...

Meena Rezkallah, P.Eng.
Jun 4, 20202 min read
2.3.7 Expansion Stress — Other Solutions
Often expansion stress problems are due to the use of fittings with large stress intensification factors (SIF). In these cases, it may be...

Meena Rezkallah, P.Eng.
Jun 3, 20201 min read


2.3.5 Simplified Expansion Stress Check
The concept that addition of expansion loops reduces the expansion stress range in a system is recognized by the B31.3 code (and others)....

Meena Rezkallah, P.Eng.
Jun 3, 20202 min read


2.3.4 Use of Expansion Loops in Piping Design & Stress Analysis
In the event that model refinement is not sufficient to solve the problem (i.e., there is a real problem, and not just one on paper), something must be done. Re-examining the equation for the guided cantilever model: It is evident that the stress analyst cannot easily change the terms 6, E, R, or delta. This leaves only 1, the length of the leg absorbing the thermal growth. This can be done through the addition of an expansion loop. In this case, the thermal growth is partial

Meena Rezkallah, P.Eng.
Jun 3, 20201 min read


2.3.3 Refining the Model Through the Use of Restraint Stiffnesses
What if the calculated expansion stress range is too high? How can we reduce it? Consider the initial example, with the pipe fully anchored at its ends. What would happen in real life? The restraints would probably bend some under the enormous load, allowing some piping expansion, which would then reduce the internal load (since expansion loads are self limiting). What happens if the bending of a support — i.e., its flexibility — is explicitly considered in the analysis? (No

Meena Rezkallah, P.Eng.
Jun 3, 20202 min read
bottom of page
